REX FW 1.10 Is Out!

Another update!

REX-receivers firmware 1.10 is out!

New features:

• Telemetry support by DITEX Servos has been implemented. In the receiver configuration (either via JETIBOX or the Device Explorer menu at DC/DS transmitters), go to Alternative Pins Functions and select the “DITEX” output type instead of “Servo” for each receiver port where the DITEX servo is connected. Minimum required version of the DITEX servos firmware is 1.17.
• If one of the E1/E2 ports is now configured as a PPM or UDI output and the other of these ports is a PPM input with a connected satellite receiver, the data signal is generated on the PPM or UDI output even though the receiver itself loses signal from the transmitter – it takes data from the satellite.
  – If the “Direct” output type is selected in the receiver, the PPM/UDI signal is generated only if the receiver has valid data from the transmitter or satellite receiver.
  – If the “Computed” output type is selected in the receiver, the PPM/UDI signal is generated synchronously with the servo signal so that if there is no data from both PPM input and the transmitter, the Fail-Safe is applied accordingly (beneficial e. g. for multicopter flight controllers to use two receivers).

If you are not using Ditex-servos but are PPM/UDI-user have a go with REX-receiver and satellite! We all love redudancy, right? :)

As usual, grab the update from Jetimodel HERE!